ArubaWhere is the cold storage installedMaintenance instructions and operation steps

The polyurethane insulation board shall be connected by plug-in notch connection because it has higher strength when connecting in this way.

General quick-frozen warehouses are mostly cooled by refrigeration mechanisms, and those with very low gasification temperature are used as coolant to evaporate under low pressure and mechanical conditions, so as to absorb the heat in the warehouse so as to achieve the purpose of cooling and reduction.

Aruba.Measure the power supply voltage according to the technical requirements for fluorine filling and commissioning of refrigeration system.

The two sets of connectors between the cold storage shall be wedged tightly, and the two sets of connectors shall be fixed at the upper, outer and lower sides of the cracks in the cold storage respectively. The lower connector shall be as close as possible so as to facilitate the use of concrete to cover the connector in the future.

.Core tip: in the cold storage project, and is not prone to failure, convenient use and management and long service life.

Whether there is dirt on the condenser and poor heat dissipation will lead to too high condensation pressure of the refrigerator. In order to protect the compressor, the machine stops running under the action of the pressure controller. When the heat dissipation is good,ArubaWhere is a good place to install cold storage, press the black reset button on the pressure controller, and the machine can automatically resume operation.

For cold storage,ArubaProfessional cold storage installation, it is very common in our production and life. Cold storage is very important for food freezing and preservation, and most people choose to use cold storage for cold storage construction. Why? Why do people choose cold storage for construction? What are the advantages of cold storage? The following is a detailed introduction.

Does the unit location meet the relevant conditions? Whether the heat dissipation and pipe length can meet the requirements.

The height of the warehouse, the horizontal and vertical of the warehouse shall be designed according to the refrigeration, refrigeration equipment, transportation and stacking conditions. The selection of insulation board is very important for Guangdong cold storage. At present, the vast majority of cold storage use polyurethane insulation board. What are the characteristics and advantages of polyurethane insulation board?

For more, please check.It is built in the room. There shall be excellent drainage pipe standards around the cold storage, the soil temperature shall be low, there shall be interlayer under the cold storage, and good natural ventilation shall be maintained. Maintaining dryness is very important for the cold storage. In addition, before the construction of the cold storage, the phase electricity of the relative volume shall be built according to the output power of the refrigeration unit. If the cold storage is water-cooled and radiating, the tap water pipeline shall be paved and the FRP cooling tower shall be built.

Anti odor floor drain shall be set on the pavement of refrigeration room and refrigeration unit room, and the height width ratio of floor drain water seal shall not be less than 50mm. The elevator shaft, electronic pit and other places convenient for drainage shall be provided with drainage and equipment to avoid backflow of water.

2 - cold storage

It is equipped with temperature compensation to automatically adjust the water temperature. The water temperature of ultrasonic atomization is 15-20 degrees. If our humidifier is connected with the warehouse,ArubaInstallation of cold storage, there is no temperature compensation, even if

market price.The floor of the cold storage shall be kept as close as possible during use

When the ceiling fan is too heavy, 4 or 5 angle iron shall be used as lintel. Lintels shall span over another roof and wall panel to reduce load.

During the use of the goods yard medical cold storage project, the stored goods must be in strict accordance with the relevant regulations. The goods should have a certain distance from the ground and wall of the cold storage. When stacking, the distance between the goods and the goods must be cm. At the same time, the distance between the goods and the cold fan should also be 100 cm. No goods can be stored within this range, This is also an important content in the use of medical cold storage engineering.

Aruba.Goods in and out frequently, throughput

In the process of realizing your dream, you must remove all the influences. It is very important to recognize that when these beautiful refrigerators are built in the villa room, which makes people's retained items more convenient and reliable. With the continuous development of material technology, today's various cold storage materials emerge in endlessly, and the cold storage is different from each other. When purchasing, we should make reasonable comparison and select products suitable for our own use needs and economic conditions.