AbquikiAluminu
AbquikiElectriAbquikiLarge electric elevator,
It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations,AbquikiNew electric elevator, making high-altitude operations easier
Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.
Abquiki.The coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than 0.1mm, and there should be a 2mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electric
Construction electric elevators outside the lightning protection range
.When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, but safety should be maintained.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
The scaffolding of the parking platform should be laid tightly and firmly.
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
Equal effect.
Setting requirements: Each landing entrance should be equipped with a landing door,AbquikiElectric elevator 8 meters, which should cover the opening with its full width, and should not open towards the lifting passage.
Click to view.Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
Protective measures should comply with regulatory requirements.
quality standard.The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology, smooth lifting and low noise.
Precautions for safe use of electric elevators: Before use, remove any obstacles or debris near the electric elevator that may hinder operation, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.
Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.