SilversonElect
Silverson2 metElectric elevators used in various places.
Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a 90 degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.
Silverson.Unloading platform and attached electric construction platform, etc.
Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).
.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.
Low power consumption: When the hydraulic guide rail lifting platform descends,SilversonFloor electric elevator, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.
Stop the suspension cage.
Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, long service life low noise,SilversonElectric three wheel car lift, large load bearing capacity, and are relatively simple making them suitable for use in stage equipment.
Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site,SilversonIndoor electric elevator, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc., and the production should meet the design requirements.
Protective measures should comply with regulatory requirements.
When the door is closed, except for the gap between the lower part of the door that should not exceed 35mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table 4 of GB 23821-2009.
demand.The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.
After the limit switch is activated, only professional personnel can restore the movement of the suspension cage.
In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least 150mm above the ground.
Silverson.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around 150-300mm, and the top layer is not affected. It can be customized according to the location and environment.
Buffer. In order to increase the energy for the car to hit the top or sink to the bottom. Remove rubber or sponge from the buffer and cabin to increase their impact energy; Rope groove slipping and other accidents caused the car to suddenly fall, resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.
The scaffolding of the parking platform should be laid tightly and firmly.