OkeGuide rail hydraulic lifting platformWhat are the benefits of coatings

Reason: Cleaning method for internal leakage in the oil cylinder: Replace the sealing element of the oil cylinder. The lifting platform does not lower. Reason: The lowering valve is malfunctioning. Cleaning method: When pressing the lowering button, check whether the lowering valve is powered on. If there is no electricity, clean it as much as possible; If there is power, clear the malfunction of the lowering valve itself or replace the lowering valve. The sliding valve should be kept clean and.

The undercut length of the weld mm should not exceed 10% of the weld seam, the first step is to identify the cause of the problem. Professional elevator manufacturers have strict testing, quality assurance,OkeCylinder mounted hydraulic lifting platform, and promotional activities are ongoing. Welcome to consult

After 5000 hours of elevator operation, carry out medium maintenance on the mechanical and electrical systems.

.Lines of various safety equipment

There is a phenomenon of self stopping when running up and down. Due to poor contact of the safety protection switch it is easy for hydraulic cargo elevator manufacturers to cause this problem.

Therefore, the wholesale manufacturers of hydraulic elevators remind that there are three main ways to adjust the speed control circuit: throttling speed control circuit: quantitative pump oil supply, using flow valves to adjust the flow in and out of the actuator to achieve speed control; In the volume throttling speed control circuit, the oil is supplied by the pressure limiting variable pump, and the flow rate into the actuator is adjusted by the flow valve to adapt the flow rate of the variable pump to the regulated flow rate of the speed control valve.

The undercut length of the weld mm should not exceed 10% of the weld seam, and the depth should not exceed 0.4mm.

Therefore, the oil should be replaced regularly to ensure that the additives are effective. The filter can only absorb a limited amount of dirt particles and other impurities from the oil. Replace the filter according to the recommended cycle to keep the system clean.

The characteristics of the platform include reliable hydraulic system, simple operation, large load-bearing capacity and rear hinge support.

Test results.Surface paint quality: The paint should be smooth and flat, have good adhesion with metal, have uniform color,OkeAluminum alloy hydraulic lifting platform, no bubbles, no cracks, and there should be no wrinkles, pits, paint leakage, and sagging.

Voltage too low: Measure the starter voltage, with an allowable fluctuation range of± 10%.

Aluminum alloy elevators are different from other forms. This type of elevator is made of aluminum alloy material, which is lightweight and has a more beautiful appearance. The disadvantage is that it has a light load capacity and is only suitable for simple high-altitude maintenance work, and can only provide support for 1-2 people.

When using hydraulic elevators, frequent inspections and maintenance should be carried out, which not only extends the service life of the hydraulic elevator, but also enables it to exert greater power during operation. Of course hydraulic elevators also have their own regular repair times and protection methods: regular protection (carried out per shift).

target.When the hydraulic oil of the equipment is insufficient, it will not cause lifting. At this point,OkeFixed electric hydraulic lifting platform, you only need to add enough hydraulic oil to run.

Carefully prepare a special construction plan for installation and construction, conduct maintenance, cleaning, and replace the cleaning hydraulic oil to clean.

Oke.After 1500 hours of elevator operation, perform minor repairs to the mechanical and electrical systems.

Solution: Check if the performance of the legs is good, even if the butter is polished to increase its properties.

The manufacturer of the hydraulic cargo elevator tells you the reason and cleaning method: Reason: Overload cleaning method: Reduce the load to clean. Reason: The return valve is not closed. Cleaning method: Tighten the return valve to clean. Reason: The one-way valve of the manual pump is stuck and the return valve is malfunctioning. Cleaning method: Unscrew the bolt at the valve port of the oil pump, conduct maintenance, and replace the cleaning hydraulic oil to clean.